E - 3
DIN REAR-MOUNT (METHOD B)
Installationusing the screw holes on the sides of the unit.
Fasteningtheunit to the factory radio mounting bracket.
1. Select a position where the screw
holes of the bracket and the screw
holes of the main unit become
aligned (are fitted) and tighten the
screws at 2 places on each side.
2. Screw
3. Factoryradiomounting bracket.
4. Dashboardor Console
5. Hook(Remove this part)
Note: the mounting box, outer trim ring,
andhalf-sleeve are not used for method B
installation.
5
2
4
3
25
a. Frame
b. Insert fingers into the groove in the
front of frame and pull out to remove
the frame. (When re-attaching the
frame, point the side with a groove
downwards and attach it.)
c.Insert the levers supplied with the unit
into the grooves at both sides of the
unitas shown in figure until they click.
Pullingthe levers makes it possible to
removethe unit from the dashboard.
Trim Plate Installation:
Push the trim plate against the chassis until it is fitted.
You must do this before you install the front panel, otherwise it can't be attached.
Removing the unit
abc