Boss Audio Systems CX2000M Power and Speaker Wiring, Tri-Mode, High pass filter, filter inductor

Power and Speaker Wiring	4-Channel Amplifiers
Tri-Mode	CX600, CX650, CX800 and CX1000

Tri-mode operation allows you to connect this amplifier to a pair of main speakers plus a subwoofer on one pair of output channels. The main speakers will operate in STEREO while the subwoofer simultaneously operates in MONO.

To set up the amplifier to run in this mode, put the crossover switches in the FULL position. Insert high pass filter capacitors and a low pass filter inductor into the wiring as shown below. Be sure to check the table at the bottom of this page to determine the correct capacitor and inductor values for the crossover frequency you wish to achieve.

				SPEAKER
Tri-Mode			IMPEDANCE
				8 OHMS			RIGHT
							Subwoofer
Component values for
					High pass filter
6dB Passive Crossover
FREQUENCY INDUCTOR CAPACITOR					crossover			CH3
								Speaker
80 Hz	7.5mH	470uF						MINIMUM
100 Hz	6.5mH	330uF				High pass filter
								SPEAKER
120 Hz	5.5mH	330uF				crossover		IMPEDANCE
150 Hz	4mH	220uF						4 OHMS

				CH4
				Speaker
Low pass
filter inductor
	SPEAKER CONNECTIONS		FUSES	POWER CONNECTIONS
CH 1	CH2	CH3	CH4
				BATT+ REMOTE GROUND
	CH1/2		CH3/4
	BRIDGED		BRIDGED
					Chassis
					ground
					point
		High pass filter			to REMOTE TURN-ON
		crossover	CH2		terminal of head unit
		–
			Speaker
		+
			MINIMUM
	High pass filter			FUSE	Battery
			SPEAKER
	crossover		IMPEDANCE
		–	4 OHMS
			CH1
		+	Speaker

Low pass filter inductor

LEFT

SPEAKER Subwoofer

IMPEDANCE

8 OHMS

CHAOS EXXTREME MOSFET Amplifier User’s Manual - page 15