Bostitch manual Tool Setup, MFN-201 Tool Specifications, MFN-201 Fastener Specifications

MFN-201 TOOL SPECIFICATIONS

All dimensions in inches unless otherwise specified

			MFN-201
	Description		Manual Flooring Nailer
	Fastener Type		“L”Type 16 Gauge Flooring Cleats
	Magazine Capacity		120 cleats
	Length		13-7/16” (340mm)
	Width		3-1/2” (89mm)
	Height		17-1/2” (444mm)
	Weight		8.6 lbs (3.9kg)
MFN-201 FASTENER SPECIFICATIONS
	Tool Model	Fastener Type		Fastener SKU	Gauge	Length
	MFN-201 Manual			FLN-150	16	1-1/2”
	Flooring Nailer			FLN-200	16	2”

NOTE:

BOSTITCH tools have been engineered to provide superior customer satisfaction and are designed to achieve maximum performance when used with precision BOSTITCH fasteners engineered to the same exacting standards. BOSTITCH cannot assume responsibility for product performance if our tools are used with fasteners or accessories not meeting the specific requirements established for genuine BOSTITCH fasteners and accessories.

TOOL SETUP

The MFN-201 was designed to install 1/2” to 3/4” tongue and groove hardwood flooring. The tool is factory set for 3/4” flooring. Two additional foot plates are included with this tool to accommodate 1/2” and 5/8” flooring.

Flooring products will vary and the user must ensure the tool is properly adjusted each time flooring is being installed. Dimensions listed on the footplates are suggestions. Test fastener

placement on scrap pieces of wood before installing floor.

To change footplates:

1.Remove 4 flat head cap screws.

2.Change to desired plate.

3.Replace 4 flat head cap screws.

FASTENER PLACEMENT:
Too High	Correct

Flat head

cap screws

Too Low

4