Bostitch manual RN45B Driver Maintenance Instructions, Directional Exhaust Deflector

RN45B DRIVER MAINTENANCE INSTRUCTIONS

Worn driver causing poor quality or loss of power:

-Wear on the driving tip will affect the nail drive, giving symptoms of bent and incompletely driven nails, and damaged nail heads.

-The driver length may be adjusted to allow the driving tip to be redressed to compensate for wear. Heat and precise measurement are required. Contact a qualified service technician for this adjustment.

-The length setting for a new driver is shown below. Measurement is from the bottom face of the main piston.

-Note that the measurement from the top of the piston gives the maximum amount the driver may be adjusted to allow redressing. Always extend the driver the minimum required to allow redressing to restore the driving end; several redressings will be possible before this maximum depth is reached.

4.675” - 4.685” (118.7mm - 119.0mm)

5/32” (4.0mm) maximum limit of driver recessed into piston. Do not exceed this limit.

DIRECTIONAL EXHAUST DEFLECTOR

Loosen screw as shown. Adjust to desired exhaust direction and tighten screw.

	ACCESSORIES AVAILABLE
BC601	4 oz. Bostitch Air-Tool Lubricant
BC602	1 pint Bostitch Air-Tool Lubricant
BC603	1 pint Bostitch "Winter-Formula" Air-Tool Lubricant
BC604	1 quart Bostitch Air-Tool Lubricant
100679	O-Ring Lube 1 lb. can
SEQ5	Sequential Trip Conversion Kit
VSA2	Vinyl Siding Kit
DC6	Depth Control Kit
851325	Loctite® 271 Packet
ORK13	O-Ring Kit
BK11	Bumper Kit
FPK1	Frame Protector Kit
CNTK2	Contact Trip Conversion Kit (black trigger)
TVA6	Trigger Valve Assembly

-11-