D
W
H

Single Enclosure Design Example

-GTR TunableRadiator

Model: 12" w/ GTR12 10" w/ GTR10
H=Height: 13" (33.0cm) 9.5" (24.1cm)
W = Width: 13" (33.0cm) 9.5" (24.1cm)
D=Depth: 10.5" (266.7cm) 9.75" (24.8cm)
Gross Volume: 1.0 Ft3(28.3L) 0.5 Ft3(14.2L)
GTR Tuning / Q-TuneSetting Matrix:
Model: 12" w/ GTR12 10" w/ GTR10
Tuning Mode 1: 45Hz / 42Hz@0.7 50Hz / 45Hz@0.7
Tuning Mode 2: 35Hz / 34Hz@1.0 35Hz / 34Hz@1.0
Tuning Mode 3: 30Hz / 30Hz@1.2 30Hz / 30Hz@1.2
Enclosure dimensions are internal and include basket and GTR displacement
Tuning Assumes Boston G3, G2, or G1 Subwoofer
These enclosure shapes are examples and these dimensions can be modified provided that
the exact internal volume is retained and that there is adequate space behind the woofer and
the GTR.
34-inch thick M.D.F. is recommended as a minimum
*Recommended distance from sides and back walls of enclosure
†Q-Tune™ is a feature found on Boston GT Amplifiers
Factory Tuning Mode
B
d
6
0
6
-
2
1
-
81
-
4
2-
03
-
6
3
-
zH
501 05 001 005 0001 0002
In-Car Response w/ Q-Tune
Enclosure Response

Subwoofer w/ GTR Enclosure Shape Examples

GTR TunableRadiatorIncluded Hardware
Model: GTR12 GTR10
Hex Key 2.5mm 1 1
T-Nut M4: 8 8
Lock Washer M4: 88
Mounting Screw M4: 8 8
Wood Screw M4 x 38mm: 88
Also included with all GTR TunableRadiatorsis the GTR Tuning Hardware, these parts are
individually listed in the GTR TunableRadiatorTuning Hardware section.

GTR TunableRadiatorTuning Hardware

Small Tuning Mass*

2xLarge Tuning Mass

(1 installed* / 1 in hardware pack)

Screw*

Lock Washer*

Washer*

*Pre-installed on GTR from factory

GTR TunableRadiatorTuning Frequency Chart

For single recommended G5/GTR enclosures
Tuning Mode: GTR12 GTR10
Enclosure Volume: 1.0 Ft30.5 Ft3
Tuning Mode 1: 45Hz 49Hz
Tuning Mode 2: 35Hz 35Hz
Tuning Mode 3: 30Hz 30Hz
Weight Chart Small Tuning Mass Large Tuning Mass
Tuning Mode 1: X X
Tuning Mode 2: 1 1
Tuning Mode 3: X 2
Key:
X=No Mass Used
1=One Mass Used
2=Two Mass Used
Changing the tuning on the GTR TunableRadiators
Note: The GTR TunableRadiatorisshipped from the factory in “Tuning Mode #2”.
1.Remove the dustcap.
2.Remove the center screw, lock
washer, and washer that hold the
mass to the GTR.
3.Select the desired tuning mode by
placing the correct combination of
mass, foam side down, on the
center shaft. (use the tuning guide
located below)
4.Install the center screw, lock
washer, and washer and tighten.
5.Install the dustcap using all five
screws.
Warning: The dustcap is
astructural part of the
GTR TunableRadiator
and must be installed
before use.

Trapezoid

Rectangle

Reverse

Listed below are several single G5 subwoofer using a GTR
TunableRadiatorenclosure shape examples.

FrontTop

Side Top

Side Front

Side Top

Wedge

Side Front

Square with Down-firing GTR

142-001933-2
Boston Acoustics, Inc. 300 Jubilee Drive, Peabody, MA 01960 USA
T: 978.538.5000 F: 978.538.5100 W: bostonacoustics.com
Q-Tune, SureSet, and TunableRadiator are trademarks and Boston, Boston
Acoustics, and the Boston Acoustics logo are registered trademarks of Boston
Acoustics, Inc. Specifications are subject to change without notice.
All rights reserved. Covered by patents issued and/or pending.
©2004 Boston Acoustics, Inc.