Bounty Hunter 3300 owner manual Assembly is easy and requires no tools, Do not pull on the cable

ASSEMBLY

Assembly is easy and requires no tools.

●Position detector upright.

●Rotate the LOCKING COLLAR fully in a counter clockwise direction.

●Insert your finger inside the tube and make sure the INTERNAL CAM LOCK is flush with the inside of the tube.

●Insert the LOWER STEM into the S-ROD.

LOCKING

COLLAR

INTERNAL

CAM LOCK

SILVER BUTTON

MIDDLE

STEM

S-ROD

S-ROD MIDDLE STEM

●Rotate the LOWER STEM until the SILVER BUTTON locates in the hole.

●Twist the LOCKING COLLAR fully in the clockwise direction until it locks.

●If your detector has 3 tubes and 2 locking collars, repeat this process on the Middle Stem.

●Position the Lower Stem (the straight tube) with the Silver Button toward the back. Using the Bolt and Knurled Knob, attach the Searchcoil to the plastic extension protruding from the Lower Stem.

●Press the button on the upper end of the Lower Stem, and slide the Lower Stem into the S-Rod.

Adjust the Stem to a length that lets you maintain a comfortable upright posture, with your arm relaxed at your side, and the Searchcoil parallel to the ground in front of you.

●Wind the Cable securely around the Stem.

●Insert the Plug into the matching Connector on the right underside of the Detector Body. Be sure that the key-way and pins line up correctly.

Caution: Do not force the plug in. Excess force will cause damage.

To disconnect the cable, pull on the plug.

Do not pull on the cable.

5