BOXLIGHT SP-9t manual Remote Control Unit, Does not work

APPENDIX

Problem:	Try these Solution
Remote Control Unit	● Check the battery.
does not work.	● Make sure nothing is between Infrared Remote Receiver and Remote Control Unit.
	● Make sure you are not too far from a projector when using Remote Control Unit.
	Maximum operating range is 16.4’ (5m).
	● Make sure the code of Remote Control is set to conform to projector.
	(See “SETTING” section on page 35, 36.)

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If the problem still persists after following all operating instructions, contact Boxlight for assistance at 1-800-762-5757 or 360- 779-7901. Give the model number and explain the difficulty. We will advise you how to obtain service.

Please have the following information available.

●Serial No. of projector.

●Resolution of the computer.

●Refresh rate of computer.

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

40