![](/images/new-backgrounds/1014091/1409123x1.webp)
|
| SERVICE PROCEDURE |
|
| Thermostat Removal and Replacement |
Thermostat Removal | WARNING | |
1. | Turn power “OFF” To water heater. | High voltage exposure. Be sure power is |
2. | Remove access cover and insulation. | “OFF” when performing this procedure. |
|
3.Remove plastic thermostat protector from thermostat.
4.Disconnect wires from thermostat terminals. It may be necessary to label wires for proper
5.Note thermostat temperature setting for proper setting of new thermostat.
6.Slide thermostat upwards and out of mounting bracket.
Thermostat Replacement
1.Use a stiff brush to remove any debris or loose scale from tank surface where new thermostat will be installed.
2.Slide new thermostat down into thermostat bracket until it snaps into place. IMPORTANT! Thermostat must set completely flat or flush to tank surface. An improperly installed thermostat will cause improper water heater operation.
3.Refer to the wire diagram located on the inside of the access cover and
4.Set thermostat to the original thermostat setting found on the old thermostat.
5.
6.
7.Restore power to water heater and verify proper heater operation.
Tank Surface
Proper Thermostat mounting
flush with tank surface
Thermostat
Improper Thermostat mounting.
Thermostat not flush with tank surface
Thermostat mounting
bracket
Front View
Thermostat Mounting
Side View | Side View |
Proper Thermostat | Improper Thermostat |
Mounting | Mounting |
Page 12
12