Bradley Smoker S19-220PT, S19-220BPT Assemble eyewash, Connect water supply

Installation					S19-220PT, S19-220BPT
Installation		S19-220PT					(394mm)
							15-1/2"
Instructions
NOTE: Flush the water				7-3/8"
supply line before beginning			(187mm)
				4"
installation.				(102mm)
Supplies Required:			(210mm)	(57mm)
			8-1/4"	2-1/4"
•	(3) 3/8" wall fasteners		13-1/4"		5/16"		5-1/4"
and bolts		Ø10"	(337mm)		(8mm)
					MTG.	133mm)
•	Pipe sealant	(254mm)			HOLE
•	Piping to 1/2" IPS water
supply inlet on unit
•	Sign-mounting hardware						15-7/8"
Step 1: Install inlet		S19-220BPT
							(403mm)
drain fittings
NOTE: Top of eyewash heads				7-3/8"
should be 33"-45" (838mm-			(187mm)
				4"
1142mm) from floor.				(102mm)
	1. Position the inlet drain		8-1/4"	2-1/4"
	fitting over the 1-1/4"		(210mm)	(57mm)
			13-5/8"		5/16"
	drain outlet pipe from
		Ø10-3/4"	(346mm)		(8mm)		5-1/4"
	wall.				HOLE	133mm)
		(273mm)
					MTG.
	2. Using the inlet drain
	fitting as a template,
	mark the bolt hole
	locations on wall OR	S19-220PT
	install three suitable
		&
	fasteners (supplied by
		S19-220BPT	36" (914mm)
	installer) for 3/8" bolts
			Suggested
	in the wall at the		Height
	marked hole locations		To Floor	4-1/2"	8-3/4"	30-1/2" (775mm)
	(see Figure 1).			(114mm)	(222mm)		Suggested
							Height
	3. Bolt the inlet drain						To Floor
	fitting to the wall or		13"
	wall fasteners using		(330mm)
	3/8" bolts (supplied by	Figure 1
	installer).

Step 2: Assemble eyewash

1.Assemble eyewash components as shown in Figure 2 on page 4.

•Apply pipe sealant (supplied by installer) to all male-threaded pipe joints.

•Use a strap wrench around pipes when tightening to prevent marring.

Step 3: Connect water supply

1.Connect the water supply piping (supplied by installer) to the 1/2" IPS inlet on the eyewash.

2.Connect the P-trap and the tailpiece to the 1-1/4 IPS drain outlet on the eyewash.

3.Mount the safety sign to a wall or pipe using sign-mounting hardware (supplied by installer).

4.Open the water supply lines. Test for leaks and adequate water flow.

Bradley Corporation • 215-1251 Rev. B; EN 06-532G 4/30/07 3