Braun 3588 Inserting or changing the Braun energy cell, Filling the water tank, Switching on

1

2

st

ea

m &

straight

1 0

Before use

Inserting or changing the Braun energy cell

The energy supply must be switched off (switch C2 on position «0»). Press the release buttons (H) and pull the end cap (I) off. Insert a Braun energy cell into the handle as shown in the illustration (arrows on energy cell pointed upwards). Push the handle with the energy cell back onto the appliance until it snaps into place.

Only use Braun energy cells. These are available from the shop where this appliance was purchased, as well as from authorised Braun Service Agents. The energy cells can be taken out or changed at any time, even if they are only partly filled.

Filling the water tank

Remove the complete steam dispenser with the water tank

(A).

Open the lid (B) of the water tank and fill with water. Close the lid and slide the steam dispenser back onto the appliance.

Switching on

•Press down the lock button (C1) on top of the energy supply switch (C2) and shift the switch from 0 = off to 1 = on.

•Shift the start switch (D) down to «start» until you clearly hear a click.

•The starting indicator (F) lights up to show that the appliance starts heating up. The intensity of the light might change during operation because the appliance automatically regulates the temperature.

•After approx. 3 to 4 minutes, the ready indicator (E) turns dark.

•Only then the appliance is heated up to the optimum styling temperature and is ready for steaming & straightening.

click!
	C2
C1	0

	D
start
click!	1	0

wait
5
sec
start .
1	F
0
	11