Description

1Foil & Cutter cassette

2Long hair trimmer

3Precision setting switch («lock»)

4On/off switch

5Charging lights (green)

6Low-charge light (red)

7Cleaning light (yellow)

8Replacement light for shaving parts

9Shaver power socket

10Special cord set

11Case

Charging

The best environmental temperature for charging is between 60 °F to 95 °F / 15 °C to 35 °C. Do not expose the shaver to temperatures higher than 122 °F / 50 °C for extended periods of time.

Using the special cord set (10), connect the shaver to an electrical outlet with the motor switched off.

When charging for the first time, leave the shaver to charge continuously for 4 hours. Subsequent charges will take about 1 hour.

A full charge provides up to 45 minutes of cordless shaving time depending on your beard growth.

Shave without the cord. With normal use the shaver will be charged automatically after every cleaning in the Clean&Renew™ (see separate use instructions).

Maximum battery capacity will only be reached after several charging/discharging cycles.

5-minute quick charge (with the special cord set (10)) is sufficient for a shave.

If the rechargeable batteries are discharged, you may also shave by connecting the shaver to an electrical outlet via the special cord set.

Charging lights

The green charging lights (5) show the charge status of the batteries. The green charging light blinks when the shaver is being charged

or switched on. When the battery is fully charged, all green charging lights shine permanently, provided the shaver is switched on or connected to an electrical outlet.

Low-charge light

The red low-charge light (6) flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. The remaining capacity will then be sufficient for 2 to 3 shaves.

A Shaving

Press the on/off switch (4) to operate the shaver (picture).

The flexible shaving foils automatically adjust to every contour of your face (picture).

Long hair trimmer

To trim sideburns, moustache or beard, slide the long hair trimmer (2) upwards.

Precision setting switch («lock»)

For precise handling in hard to shave areas (e.g. under the nose) slide the switch (3) to the right to position «lock». The centre trim- mer and one foil will be lowered.

Tips for the perfect shave

For best results, Braun recommends you follow 3 simple steps:

1.Always shave before washing your face.

2.At all times, hold the shaver at right angles (90°) to your skin.

3.Stretch your skin and shave against the direction of your beard growth.

BKeeping your shaver in top shape

Cleaning indicator

Your shaver should be cleaned daily in the Clean&Renew™, and certainly when the yellow cleaning light (7) shines constantly after shaving. If this is not done, the yellow light will go out after some time. The shaver’s

8

Page 8
Image 8
Braun 370cc manual Description, Charging, Shaving, Keeping your shaver in top shape