off on
A Shaver
Your Braun Flex Integral is supplied with a Braun Clean&Charge (please see section B).
Technical specifications
•Wattage via cord set: 7 W
•Automatic power supply:
•Shaver input voltage: 12 V
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Foil release button
5
6 Switch lock
7 Switch for locking the pivoting head («head lock») and for activating the
8 On/off switch
9 Charging light
10 Shaver socket
11 Power supply cord set
Charging the shaver
•First charging: Using the power supply cord set, connect the shaver to the mains with the switch on position «off» and charge it for at least 4 hours (plug might get warm).
•Once the shaver is completely charged, shave with- out the cord until fully discharged. Then recharge to full capacity again (subsequent charges will take about 1 hour).
•A full charge will give up to 50 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles.
•Best environmental temperature range for charging is 60 °F to 95 °F / 15 °C to 35 °C.
•The charging light shows that the shaver is being charged. When the rechargeable batteries are fully charged, the charging light goes off.
If later on, the charging light comes on again, this indicates that the shaver is being recharged to maintain its full capacity.
6
