Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.
C Operating your Clean&Renew™
•Connect your Clean&Renew™ with the low voltage supply cord to the mains electricity supply.
Open the contact bow (2) by pressing the release button (3). After shaving, switch the shaver off and place it upside down into the Clean&Renew™ (without having released the shaver foil).
•Select the operation mode by toggling with the mode selector (4):
«clean» | (about 15 min) |
«clean» + «charge» | (about 75 min) |
«charge» | (about 60 min) |
The corresponding lights will come on. (With cord shavers, only the «clean» function can be selected.)
•Slide down the contact bow to connect the shaver and to start the selected programme. If no programme is selected, the default function «clean» will be started.
•Do not interrupt a running programme,
as it leaves the shaver wet and not fit for use. If interruption is needed nonetheless, press the release button.
•After a programme has finished, the corre- sponding light will go out. Prior to the next shave, press the release button to release the shaver.
•When the «cartridge» light starts flashing, the remaining fluid in the cartridge is sufficient for about 5 more cleaning cycles. After these 5 cycles, the cleaning performance will be reduced and the cartridge has to be replaced.
•When the «cartridge» light illuminates constantly, the cleaning function is locked and a new cartridge has to be installed. Only then, the next cleaning cycle can be started.
•A cleaning cartridge should be sufficient for about 30 cleaning cycles. With daily use, the cleaning cartridge should be replaced approx. every 4 weeks.
•The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surround- ing air. Each cartridge, if not used daily, should be replaced after approx. 8 weeks.
•Clean the housing from time to time with a damp cloth, especially the opening where the shaver rests.
Subject to change without notice.
This product conforms to the European Directives EMC 89/336/EEC and Low Voltage 73/23/EEC.
For electric specifications, see printing on the special cord set.
Please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place
at a Braun Service Centre or at appropriate collection points provided in your country.
17
