Technical specifications
Wattage via low voltage adapter:
9 W (type 5612) / 1.5 W (type 5610). Input voltage: 110 V /
Description
1Shaver foil
2Cutter block
3Release button
4On/off switch
5Long hair trimmer
6Charging light
7Charging stand with low voltage adapter
Charging the shaver
•First charging: Charge the shaver in its charging stand for at least 4 hours (type 5610: 16 hours). Charging stand and adapter might get warm. Once the shaver is completely charged, shave until fully discharged. Then recharge to full capacity again (subsequent charges will take about 1 hour [type 5610: 8 hours]).
•The charging light shows that the shaver is being charged. When the rechargeable battery is fully charged, the charging light goes off. If later on, the charging light comes on again while the shaver is in the charging stand, this indicates that the shaver is being recharged to maintain its full capacity.
•A full charge will give up to 40 minutes of cordless shaving time depending on your beard growth (type 5610: 8 hours charging time will give 30 minutes, 16 hours charging time will give 40 minutes of shaving time). However, the maximum battery capacity will only be reached after several charging / discharging cycles. Best environmental temperature range for charging is 60 °F to 95 °F / 15 °C to 35 °C.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it allows the controlled trimming of moustache or sideburns.
Tips for the perfect shave
•It can take
•We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.
•Hold the shaver at right angles (90°) to the skin.
•Stretch your skin and shave against the direction of beard growth.
•Replace the shaver foil and cutter block every 18 months, or when the parts are worn, to ensure optimum shaving performance.
Cleaning
The
Regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under hot running water is an easy and fast way to keep it clean:
•Switch the shaver on (cordless) and rinse the shaving head under hot running water. A natural based soap may also be used provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. Next, switch the shaver off and press the release buttons. Lift the shaver foil off and pull the cutter block out. Then leave the disassembled shaving parts to dry.
6
