Before using Clean&Renew™
For the first charge of the shaver, connect the special cord set directly to the shaver, charge it for 4 hours and shave at least once.
Only then can the shaver be cleaned or recharged in the Clean&Renew™.
If the rechargeable batteries are discharged, select the combined «clean + charge» program rather than the «clean» program alone.
Installing the cartridge
Press the lift button (12) to open the housing.
Hold the cartridge down on a flat, stable surface
(e.g. table). Carefully remove the lid from the cartridge. Slide the cartridge into the base as far as it will go.
Slowly close the housing by pushing it down until it locks.
Replacing the cartridge
After having pressed the lift button to open the housing, wait for a few seconds before removing the used car- tridge.
Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.
Operating your Clean&Renew™
•Use the special cord set from your shaver and plug it into the Clean&Renew™ and then into an electrical outlet.
Open the contact bow (13) by pressing the release button (14). After shaving, switch the shaver off and place it upside down into the Clean&Renew™ (without having released the shaver foil).
•Select the operation mode by toggling with the mode selector (15):
clean
clean + charge charge
The corresponding lights will come on.
(With cord shavers, only the «clean» function can be selected.)
7526
2 1
new
old new
| 3 |
olck | 2 |
1
0
7526
| 3 | on/off |
out |
| clea |
mati | 2 | n |
ck | charge | |
col |
|
|
| 1 | cartri |
| 0 | dge |
11
