Technical specifications
•Power consumption:
•3 W when cleaning
•7 W when charging
•Power supply: 100
•Input voltage: 12 V
Before using Clean&Charge
Only applies for cordless shavers:
For the first charge of the shaver, connect
the low voltage supply cord directly to the shaver, charge it for 4 hours and shave at least once.
Only then can the shaver be cleaned or recharged in the Clean&Charge.
If the rechargeable batteries are discharged, select the combined «clean» + «charge» programme rather than the «clean» programme alone.
Installing the cartridge
•Press the lift button (12) to open the housing.
•Hold the cartridge down on a flat, stable surface (e.g. table). Carefully remove the lid from the cartridge. Slide the cartridge into the base as far as it will go.
•Slowly close the housing by pushing it down until it locks.
Replacing the cartridge
After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge.
Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.
7630
1
new
old new
17
