Braun BS 9782, BS 9785, BS 9781, BS 9791 manual Before shaving, Installing the Clean&Renew station

Before shaving

Prior to first use you must connect the shaver to an electrical outlet using the special cord set i or alternatively proceed as below.

Installing the Clean&Renew station

•Using the special cord set i, connect the

station power socket 6 to an electrical outlet.

•Press the lift button 2 to open the housing.

•Hold the cleaning cartridge 7 down on a flat, stable surface (e.g. table).

•Carefully remove the lid from the cartridge.

•Slide the cartridge into the base of the station as far as it will go.

•Slowly close the housing by pushing it down until it locks.

The The cleaning fluid display 1 will show how much fluid is in the cartridge:

«high»	up to 30 cleaning cycles available
«low»	up to 7 cleaning cycles remaining
«empty»	new cartridge required

Charging and cleaning the shaver

Insert the shaver head down into the cleaning station. (The contacts t on the back of the shaver will align with the contacts 3 in the cleaning station).

If required, the Clean&Renew station will now charge the shaver. The hygiene status of the shaver will also be analyzed and one of the following cleaning program diodes 5 will light up:

«clean» shaver is clean

«eco» short economical cleaning required «normal» normal level of cleaning required «intensive» high intensive cleaning required

clean

eco

normal intensive

autoselect

			ng
			eco
			normal
			intensive
			ct
	high		auto sele
1	low
	empty
			2
		fa	new

	high	high
low	low	low
empty	empty	empty

trimmer

washable

g

rt cleani	ng
sta		clean

eco

normal

intensive

auto select

23