Braun TYPE 5375 manual How to epilate, Charging, Preparing your skin, Preparing the appliance

Charging

•Before use, charge the appliance. For best performance, we recommend that you always use a fully charged appliance. Using the special cord set, connect the appliance to an electrical outlet with the motor switched off. Charging time is approximately 1 hour.

•The green charging light (5a) flashes to show that the epilator is being charged. When the battery is fully charged, the charging light shines permanently. Once fully charged, use the appliance without cord.

•When the red low-charge light (5b) comes on, connect the appliance to an electrical outlet via the special cord set to recharge.

As a safety feature, it may happen that in a low-charge mode, the appliance turns off. Then both charging lights flash (green/ red). In this case, simply turn back the switch to «0» and recharge the appliance as required.

•A full charge provides up to 40 minutes of cordless operation time. Maximum battery capacity will only be reached after several charging/discharging cycles.

•The best environmental temperature for charging is between 5 °C and 35 °C.

Preparing your skin

Your skin must be dry and free from grease or cream.

Optional skin cooling: For the first few epilations or if you have sensitive skin, you can use the cooling application, recom- mended by dermatologists to help reduce possible skin irritation.

•Ensure that the gel pack has been in the deep freezer (***) for at least 2 hours (for

convenience you can store the gel packs in the freezer).

•Insert the gel pack underneath the glove‘s transparent foil. Use only with glove.

•Put transparent (cool) side of the glove on your leg.

•Start cooling for approx. 1/2 minute, longer if needed.

•Epilate the cooled skin area immediately.

•Repeat cooling and epilating until completion.

•While epilating, please ensure your skin is dry.

Important: Apply cooling glove to the same area for no longer than 2 minutes. Keep away from sunlight. Do not use gel pack when damaged. Dispose of in household waste. Do not use if you are hypersensitive, allergic to the cold, or if your skin suffers from sensory disturbances, when suffering from cardiac diseases or arterial circulatory disorders.

Preparing the appliance

•Before use, always make sure that the epilation head is clean.

•Always make sure that the epilation head

(2)is provided with a cap.

•To change caps, press their lateral ribs and pull off.

•To change heads, press the release button

A How to epilate

1Turning on

•Press one of the lock keys and turn the switch clockwise to setting 2 (optimum setting). For reduced speed, choose setting 1 (soft setting).

•The «smartlight» comes on instantly and shines as long as the appliance is switched on. It reproduces an almost

8