Breville ESP6/8 Operating Your Espresso/Cappuccino Machine, OPERATING cont’d, Pre-Warming Cups

Models: ESP6/8

1 10
Download 10 pages 22.69 Kb
Page 4
Image 4
OPERATING YOUR ESPRESSO/CAPPUCCINO MACHINE

OPERATING YOUR ESPRESSO/CAPPUCCINO MACHINE

OPERATING cont’d

BEFORE USING YOUR

ESPRESSO MACHINE

Wash the filter holder and the stainless

filters in mild detergent and water.

Rinse thoroughly.

FILLING THE WATER TANK

Ensure the Power switch and Selector Control are set to the ‘OFF’ position.

Turn off at the power outlet and unplug the power cord.

Lift up the water tank lid and remove the water tank. Fill with cold water to the maximum mark and replace in the machine, pressing down firmly so that the water valve opens. Close the water tank lid.

PRE-HEATING THE MACHINE

For optimal crema, it is recommended to carry out a complete brewing operation with water but without any coffee grinds before making your first coffee to ensure that the machine has been preheated.

Make sure the selector control is in the ‘OFF’ position.

Plug the power cord into a 230/240V electrical outlet, switch on and set the power switch to the ‘ON’ position.

As soon as the orange ‘heating’ light turns off, set the selector control to the ‘ESPRESSO’ position and run a small amount of water through the brewing head for a few seconds without the filter holder in place.

PREPARING THE COFFEE

Place the 1 or 2 cup filter into the filter holder and fill with espresso coffee (use the smaller filter for 1 cup and the larger filter for 2 cups).

Use 1 level measure of espresso coffee for the 1 cup filter and 2 level measures for the 2 cup filter. It is important to use the correct amount of coffee as the filter perforations have been constructed for optimal pressure build up in the machine.

Clean any excess coffee from the rim of the filter holder to ensure a proper fit under the brew head.

Place the filter retainer clip in the release position, by pulling the clip back towards your hand.

Place the filter holder underneath the

brew head so that the handle is positioned

to the left of centre. Lift the filter holder

until it contacts the brew head and rotate

PRE-WARMING CUPS

For optimal coffee temperature, pre-warm the espresso cups by placing them on the cup warming plate.

The water tank should be filled with fresh cold water before use

Check water level before use and replace the water daily

Do not use mineral or distilled water

Distribute the coffee evenly and press it lightly with the bottom of the measuring spoon (if there is too much coffee, the flow of water can become blocked).

to the right.

6

7

Page 4
Image 4
Breville ESP6/8 manual Operating Your Espresso/Cappuccino Machine, OPERATING cont’d, Before Using Your Espresso Machine