Portable Generator
12
GENERAL MAINTENANCERECOMMENDATIONS
The Owner/Operator is responsible for making sure that
all periodic maintenance tasks are completed on a timely
basis; that all discrepancies are corrected;and that the unit
is kept clean and properly stored.NEVER operate a
damaged or defective generator.

Engine Maintenance

See engine owner’s manual for instructions.
CAUTION!Avoid prolonged or repeated skin
contact with used motor oil. Used motor oil has
been shown to cause skin cancer in certain
laboratory animals.Thoroughly wash exposed areas
with soap and water.
KEEP OUT OF REACH OF CHILDREN.DON'T
POLLUTE. CONSERVE RESOURCES.RETURN
USED OIL TO COLLECTION CENTERS.

Generator Maintenance

Generator maintenance consists of keeping the unit clean
and dry.Operate and store the unit in a clean dry
environment where it will not be exposed to excessive
dust, dirt,moisture or any corrosive vapors. Cooling air
slots in the generator must not become clogged with snow,
leaves or any other foreign material.
NOTE: DO NOTuse a garden hose to clean generator.
Water can enter engine fuel system and cause problems.In
addition,if water enters generator through cooling air slots,
some of the water will be retained in voids and cracks of
the rotor and stator winding insulation.Water and dirt
buildup on the generator internal windings will eventually
decrease the insulation resistance of these windings.

Battery Maintenance

Other than float charging, described elsewhere,no
maintenance is required for the starting battery.Keep the
battery and terminals clean and dry.
IMPORTANT: Battery charging should be performed in a
dry location, such as inside a garage.

To Clean the Generator

CAUTION! NEVER insert any object or tool
through the air cooling slots,even if the engine is
not running.
Use a damp cloth to wipe exterior surfaces clean.
A soft bristle brush may be used to loosen caked on dirt
or oil.
A vacuum cleaner may be used to pick up loose dirt and
debris.
Low pressure air (not to exceed 25 psi) may be used to
blow away dirt.Inspect cooling air slots and opening on
generator.These openings must be kept clean and
unobstructed.