Pressure Washer
4
ASSEMBLYIMPORTANT: Read entire owner’s manual before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From
Carton
1. Remove parts bag,accessories, and inserts included
with pressure washer.
2. Slice two corners at end of carton from top to
bottom so panel can be folded down flat.
3. Remove pressure washer from carton.
PREPARING PRESSUREWASHER FOR USEIf you have any problems with the assembly of your
pressure washer or if parts are missing or damaged,call the
pressure washer helpline at 1-800-743-4115.If calling for
assistance, please have the model,revision, and serial
number from the data tag available.
To prepare your pressure washer for operation,you
will need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle to main unit.
3. Add oil to the engine crankcase.
4. Add fuel to the fuel tank.
5. Connect high pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
Attach Handle
1. Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure 1).
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit
(Figure 2).Tighten by hand.
3. Insert one “L” hook through hole just under billboard
on left side of handle (viewing from rear of unit).Hold
hook in place with a pliers and attach locknut with a
7/16” wrench (Figure 3).
4. Insert other “L” hook through hole just above
billboard on right side of handle (viewing from rear of
unit). Hold hook in place with a pliers and attach
locknut with a 7/16” wrench (Figure 3).
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to engine owners manual to add recommended oil
to engine.
NOTE:Check Oil Often During Engine Break–in.
Add Fuel
WARNING! NEVER fill fuel tank indoors.NEVER
fill fuel tank when engine is running or hot.Allow unit
to cool for two minutes before refueling.DO NOT
light a cigarette or smoke when filling the fuel tank.
Align Holes
Handle
Handle
Supports
Figure 1 — Attach Handle to Base
Figure 2 — Secure Handle
Hose Hook
Spray Gun
Hook
Figure 3 — Attach “L” Hooks to Handle