Pressure Washer Rinsing

SpeedClean™ 2400 PSI Pressure Washer

Pressure Washer Rinsing

For Rinsing:

1.Slide the nozzle backward to high pressure, press the trigger and wait for the detergent to clear.

NOTE: You can also stop detergent from flowing by simply removing chemical injection hose from bottle.

3.Apply a high pressure spray to a small area, then check the surface for damage. If no damage is found, it is okay to continue cleaning.

4.Start at the top of the area to be rinsed, working down with same overlapping strokes as you used for washing and applying detergent.

2.Keep the spray gun a safe distance from the area you plan to spray.

For Rinsing: WARNING

High pressure spray could cause you to fall if you are too close to the cleaning surface.

Keep spray nozzle between 8 to 24 inches away from cleaning surface.

Operate this unit on a stable surface.

Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.

Firmly grasp spray gun with both hands when using high pressure spray to avoid injury if gun kicks back.

Automatic Cool Down System

(Thermal Relief)

If you run the engine on your pressure washer for

3-5 minutes without pressing the trigger on the spray gun, circulating water in the pump can reach temperatures above 125°F.The system engages to cool the pump by

discharging the warm water onto the ground.

11

Page 11
Image 11
Briggs & Stratton 020227-0 owner manual Pressure Washer Rinsing, Automatic Cool Down System, Thermal Relief, For Rinsing