Briggs & Stratton 020252 owner manual Checklist Before Starting Engine, Screen. do not

Models: 020252

1 32
Download 32 pages 47.06 Kb
Page 8
Image 8

Section 3: Assembly

Figure 3 — Connect High Pressure Hose to Spray Gun

Connect high pressure hose here.

NOTE: Remove and discard all pump shipping caps before attaching hoses.

2.Similarly, attach other end of high pressure hose to the high pressure outlet on pump. Pull down on collar of quick connect, slide onto pump and let go of collar. Pull on hose to be sure of a tight connection.

3.Before connecting garden hose to water inlet, inspect inlet screen (Figure 4). Clean screen if it contains debris or replace if damaged. Refer to the section “O-Ring Maintenance” if inlet screen is damaged. DO NOT run pressure washer if inlet screen is damaged.

Figure 4 — Connect Garden Hose to Water Inlet

Inspect inlet

screen. DO NOT

use if damaged;

clean if dirty.

4.Run water through garden hose for 30 seconds to clean out any debris.Turn off water.

IMPORTANT: DO NOT siphon standing water for the water supply. Use ONLY cold water (less than 100°F).

5.Connect garden hose (not to exceed 50 feet in length) to water inlet.Tighten by hand (Figure 4).

CAUTION

There MUST be at least ten feet of unrestricted garden hose between the pressure washer inlet and any flow shut off device, such as a ‘Y’ shut-off connector or other convenience-type water shut-off valve.

Damage to equipment resulting from failure to follow this instruction will void warranty.

6.Turn ON water and squeeze trigger on spray gun to purge pump system of air and debris.

WARNING

High pressure spray can cause paint chips or other particles to become airborne.

Always wear eye protection when using this equipment or in vicinity of where equipment is in use.

Before starting the pressure washer, be sure you are wearing adequate eye protection.

Checklist Before Starting Engine

Review the unit’s assembly to confirm you have performed all of the following:

1.Make sure handle is secure.

2.Make sure oil dipstick is installed into pump.

3.Check for properly tightened hose connections.

4.Check to make sure there are no kinks, cuts, or damage to high pressure hose.

5.Check that oil has been added to proper level in engine crankcase.

6.Add proper gasoline to fuel tank.

7.Provide a proper water supply (not to exceed 100°F).

8.Be sure to read “Safety Rules” and “How To Use Your Pressure Washer” before using pressure washer.

8

Page 8
Image 8
Briggs & Stratton 020252 owner manual Checklist Before Starting Engine, Screen. do not