MAINTENANCE
GENERATOR
MAINTENANCE
The generator warranty does not cover items that have been subjected to operator abuse or neglect.To receive full value from the warranty, the operator must maintain the system as instructed in the engine operator’s manual.
All adjustments should be made at least once each season. Follow the requirements in the engine operator’s manual.
Generator maintenance consists of keeping the unit clean. Operate the unit in an environment where it will not be exposed to excessive dust, dirt, moisture or any corrosive vapors. Cooling air louvers on the enclosure must not become clogged with snow, leaves, or any other foreign material.
Check the cleanliness of the unit frequently and clean when dust, dirt, oil, moisture or other foreign substances are visible on its exterior/interior surface.
NOTE: DO NOT use direct spray from a garden hose to clean generator.Water can enter the engine and generator and cause problems.
Changing Engine Oil
•Place the oil drain tube into an approved container.
•Push in and rotate the oil drain fitting 1/4 turn counterclockwise. Slowly pull outward until oil starts draining (Figure 5). DO NOT pull the oil drain fitting off the engine.
Figure 5 — Oil Drain Fitting
•When the oil has drained, push the oil drain fitting in and rotate 1/4 turn clockwise until it locks in place.
•Slide the oil drain tube up into the clamp on the generator.
CAUTION
Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.
•Refer to engine manual for oil fill information.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
To fill your engine with oil:
•Follow the synthetic oil grade recommendation and oil fill instructions given in the engine operator’s manual.
To Clean the Generator
• Use a damp cloth to wipe exterior surfaces clean.
CAUTION
Improper treatment of generator can damage it and shorten its life.
•DO NOT expose generator to excessive moisture, dust, dirt, or corrosive vapors.
•DO NOT insert any objects through cooling slots.
•Use a soft, bristle brush to loosen caked on dirt, oil, etc.
•Use a vacuum cleaner to pick up loose dirt and debris.
•Use low pressure air (not to exceed 25 psi) to blow away dirt. Inspect cooling air slots and openings on the generator. These openings must be kept clean and unobstructed.
When Calling the Factory
You must have the following information at hand if it is necessary to contact a local service center regarding service or repair of this unit:
1.Obtain the unit Model Number and Serial Number from the unit data decal. See “Know Your Home Generator System” diagram for location.
2.Obtain the engine Model/Type/Code numbers from the engine label. See “Know Your Home Generator System” diagram for location. Please note that the model number may vary slightly from that presented herein.
STORAGE
The Briggs & Stratton Home Generator System is designed for continuous backup operational duty. As such, there is no need to take any storage precautions. However, if it becomes necessary to take the system out of service for an extended period, call Briggs and Stratton Technical Services at
16
