Operation Section
4
HOW TO USE YOUR
7.Place colored quick connect spray tips in slots on holder that’s attached to nozzle extension (Figure 11).
PRESSURE WASHER
If you have any problems operating your pressure washer, please call the pressure washer helpline at
To Start Pressure Washer
To start your pressure washer for the first time, follow these instructions
1.Place pressure washer near an outside water source capable of supplying water at a flow rate greater than 3.7 gallons per minute and no less than 20 PSI at pressure washer end of garden hose.
2.Check that high pressure hose is connected to spray gun and to pump. See “Preparing Pressure Washer for Use” for illustrations.
3.Make sure unit is in a level position.
4.Connect garden hose to water inlet on pressure washer pump. Turn ON water.
CAUTION
DO NOT run the pump without the water supply connected and turned on.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
5.Squeeze trigger on gun until you have a steady stream of water.This purges pump of air and impurities.
6.Attach nozzle extension to spray gun (Figure 10). Tighten by hand.
Figure 10 — Connect Nozzle Extension to Spray Gun
Figure 11 — Install Spray Tips in Holder
8.Choose spray tip you want to use and insert it into nozzle extension. See “How to Use Spray Tips” on page 10.
9.Engage safety latch to spray gun trigger (Figure 12).
Figure 12 — Spray Gun with Safety Latch Engaged
Safety Latch
10.Move variable pressure control lever to “High” position, shown on engine as a rabbit (Figure 13).
Figure 13 - Variable Pressure Control Lever
9
