ASSEMBLY
ASSEMBLY
IMPORTANT: Read entire operator’s manual before you attempt to assemble or operate your new pressure washer.
Unpack the Pressure Washer
1.Remove everything from carton except pressure washer.
2.Open carton completely by cutting each corner from top to bottom.
3.Remove pressure washer from carton.
Carton Contents
Items in the carton include:
•Main Unit
•Handle
•Plastic Accessory Tray
•High Pressure Hose
•Spray Gun
•Nozzle Extension with Quick Connect Fitting and Tip Holder
•Parts Bag (which includes the following):
•Operator’s Manual
•Engine Manual
•Safety Goggles
•Maintenance Kit
•Hose Fittings
•Quick Connects
•Bag containing 4
•Handle Fastening Hardware Kit (which includes):
•Carriage Bolt
•“L” Bolts (2)
•Plastic Knobs (3)
•Tree Clips (4)
If parts are missing or damaged, contact the local Briggs & Stratton service center.
PREPARING PRESSURE WASHER FOR USE
To prepare your pressure washer for operation, you will need to perform these tasks:
1.Attach handle to main unit, then attach accessory tray to handle.
2.Add oil to engine crankcase.
3.Add fuel to fuel tank.
4.Connect high pressure hose to spray gun and pump.
5.Connect water supply to pump.
6.Attach nozzle extension to spray gun.
7.Select/attach quick connect spray tip to nozzle extension.
Attach Handle and Accessory Tray
1.Place handle onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 2).
Figure 2 — Attach Handle to Base
Handle
Align Holes 
Handle
Supports
NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.
7
