Briggs & Stratton 20341 manual Assembly, Unpack Pressure Washer, Attach Handle and Accessory Tray

Assembly

Read entire operator’s manual before you attempt to assemble or operate your new pressure washer.

Your pressure washer requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your pressure washer, please call the pressure washer helpline at

(800)743-4115. If calling for assistance, please have the model, revision, and serial number from the identification label available.

Unpack Pressure Washer

1.Remove the parts bag, accessories, and inserts included with pressure washer.

2.Open carton completely by cutting each corner from top to bottom.

3.Ensure you have all included items prior to assembly.

Items in the carton include:

•Main Unit

•Handle

•High Pressure Hose

•Spray Gun

•Nozzle Extension with Quick Connect Fitting

•Plastic Accessory Tray

•Oil Bottle

•Parts Bag (which includes the following):

•Safety Goggles

•Operator’s Manual

•Owner’s Registration Card

•Bag of 4 Multi–Colored Spray Tips

•Handle/Accessory Tray Fastening Hardware Kit (which includes):

•Carriage Bolts (2)

•Plastic Knobs (2)

•Tree Clips (4)

To prepare your pressure washer for operation, you will need to perform these tasks:

1.Fill out and send in registration card.

2.Attach handle and accessory tray to main unit.

3.Add oil to engine crankcase.

4.Add fuel to fuel tank.

5.Connect high pressure hose to spray gun and pump.

6.Connect water supply to pump.

7.Attach nozzle extension to spray gun.

8.Select/attach quick connect spray tip to nozzle extension.

Attach Handle and Accessory Tray

1.Place handle (A) onto handle supports (B) connected to main unit. Make sure holes (C) in handle align with holes (C) on handle supports.

A

C

B

NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.

2.Insert carriage bolts (D) through holes from back of unit and attach a plastic knob (E) from front of unit. Tighten by hand.

E

D

3.Place accessory tray (F) over holes (H) on handle (viewing from front of unit). Push the tree clips (G) into the holes until they sit flat against the accessory tray.

H

G

F

4.Insert multi–colored spray tips and other supplied accessories in spaces provided in accessory tray. See How to Use Accessory Tray.

8 BRIGGSandSTRATTON.COM