Briggs & Stratton 30201 owner manual Assembly, Install Wheel Kit, Remove Generator From Carton

PowerBOSS™ 6200W Portable Generator ASSEMBLY

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your

•Generator and engine owner’s manuals

•Engine oil

•Wheel kit

Install Wheel Kit

generator, please call the generator helpline at 1-800-743-4115.

Remove Generator From Carton

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Carton Contents

Check all contents. If any parts are missing or damaged, call the generator helpline at 1–800–743–4115.

•The generator

Figure 1 — Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use. You will need the following tools to install these components:

•1/2" or 13mm wrench

•7/16" wrench

•Socket wrench

•1/2" or 13mm socket

•7/16" socket

•Pliers

Refer to Figure 1 and install the wheel kit as follows:

1.Tip generator so that engine end is up.

2.Slide axle through both mounting brackets.

3.Place a wheel on each side with air valve facing out.

Handle Pin

Nylon Washer

Nylon Washer

45 mm Cap Screw Flat Washer

Nut

Wheel

Handle

Use existing hardware to attach left side of support leg to unit

Nut

Flat Washer

Axle

20 mm Cap Screw

Vibration Mount

Support Leg E-Ring

3/4” Cap Screw Nut

6