Briggs & Stratton 30230 manual Assembly, Unpack the Generator, Carton Contents, Install Wheel Kit

PowerBOSS™ 5600W Portable Generator ASSEMBLY

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available. See “Features and Controls” for data tag location.

Unpack the Generator

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Carton Contents

Check all contents against those listed below:

•Main unit

•Engine oil

•Operator’s manual

•Engine operator’s manual

•Wheel kit

If any parts are missing or damaged, call the generator helpline at 1-800-743-4115.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use. You will need the following tools to install these components:

•2 - 13mm wrenches

•Socket wrench with a 13mm socket

•Pliers

•Safety glasses

Refer to Figure 1 and install the wheel kit as follows:

1.Tip generator so that engine end is up.

2.Slide axle through both mounting brackets.

3.Place a wheel on each side with raised hub inboard.

4.Place a washer on axle and then place an e-ring in axle groove.

5.Install e-ring with pliers, squeezing from top of e-ring to bottom of axle.

CAUTION

E-rings can cause eye injury.

E-rings can spring back and become airborne when installing or removing.

• Always wear eye protection when installing/removing e-rings.

Figure 1 — Install Wheel Kit

Capscrew
Nut
Handle		Wheel
		Washer
	Axle
Mounting Leg	Capscrew
		E-Ring
	Nut
	6