Briggs & Stratton 30244 General Recommendations, Generator Maintenance, Generator Cleaning

MAINTENANCE

GENERAL RECOMMENDATIONS

Regular maintenance will improve the performance and extend the life of the generator. See any authorized dealer for service.

The generator’s warranty does not cover items that have been subjected to operator abuse or negligence.To receive full value from the warranty, the operator must maintain generator as instructed in this manual.

Some adjustments will need to be made periodically to properly maintain your generator.

All service and adjustments should be made at least once each season. Follow the requirements in the “Maintenance Schedule” chart below in Figure 14.

NOTE: Once a year you should clean or replace the spark plug and replace the air filter. A new spark plug and clean air filter assure proper fuel-air mixture and help your engine run better and last longer.

environment where it will not be exposed to excessive dust, dirt, moisture or any corrosive vapors. Cooling air slots in the generator must not become clogged with snow, leaves, or any other foreign material.

Check the cleanliness of the generator frequently and clean when dust, dirt, oil, moisture or other foreign substances are visible on its exterior surface.

NOTE: DO NOT use a garden hose to clean generator. Water can enter the engine fuel system and cause problems. In addition, if water enters the generator through cooling air slots, some of the water will be retained in voids and cracks of the rotor and stator winding insulation.Water and dirt buildup on the generator internal windings will eventually decrease the insulation resistance of these windings.

Generator Cleaning

Daily or before use, clean accumulated debris from generator. Keep linkage, spring and controls clean. Keep area around and behind muffler free from any combustible debris. Inspect cooling air slots and openings on the generator. These openings must be kept clean and unobstructed.

GENERATOR

MAINTENANCE

Generator maintenance consists of keeping the unit clean and dry. Operate and store the unit in a clean dry

Generator parts should be kept clean to reduce the risk of overheating and ignition of accumulated debris.

•Use a damp cloth to wipe exterior surfaces clean.

•Use a soft bristle brush to loosen caked on dirt, oil, etc.

Figure 14 – Maintenance Schedule

FILL IN DATES AS YOU			SERVICE DATES
COMPLETE REGULAR SERVICE
						SERVICE DATES
MAINTENANCE TASK	Before	Every 25	Every 50	Every 100 Hours	Every 100
	Each Use	Hours or Yearly	Hours or Yearly	or 6 months	Hours or Yearly
Check oil level	X
Clean debris	X
Clean fuel valve				X
Change engine oil and oil filter					X¹
Service foam pre-filter		X
Service air filter			X²
Service spark plug					X
Service spark arrester					X
Adjust valve clearance			X
Prepare for storage		If unit is to remain idle for longer than 30 days.

¹Change oil after the first (8) operating hours and every 100 hours or every year, whichever occurs first, thereafter. Change sooner when operating under dirty or dusty conditions.

²Replace more often under dirty or dusty conditions.

16