274277
CAUTION: This engine is shipped from Briggs & Stratton without oil. Check oil level before starting engine. If you start the engine without oil, the engine will be damaged beyond repair and will not be covered under warranty.
OIL CAPACITY
Engine without oil filter holds approximately
Engine equipped with oil filter holds approximately 2 quarts (64 ounces; 1.9 liters).
TYPE OF OIL TO USE
•Use a high quality detergent oil classified “For Service SF, SG, SH, SJ” or higher, such as Briggs & Stratton 30W, Part Number 100005 (20 oz) or 100028 (48 oz).
•Do not use special additives.
•Choose a viscosity according to the table opposite.
Note: Synthetic oil meeting ILSAC
OIL
SAE Viscosity Grades
|
|
| ** |
|
|
|
| |
|
|
|
|
| * |
|
|
|
° F | 0 | 20 | 32 | 40 | 60 |
| 80 | 100 |
° C | 0 |
| 10 | 20 | 30 | 40 | ||
STARTING TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
*CAUTION: Air cooled engines run hotter than automotive engines. The use of
**CAUTION: SAE 30 oil, if used below 40° F (4° C), will result in hard starting and possible engine bore damage due to inadequate lubrication.
CHECKING AND ADDING OIL
• | Check oil level before starting the engine. | • | Keep oil level at FULL. |
• | Check level daily, or after every eight (8) hours. | • | Do not overfill. |
FULL
[1]Remove oil fill cap (if equipped). Pour oil slowly.
[2]Fill to FULL line on dipstick – recheck.
[3]Replace dipstick firmly.
Oil Fill
[4]Place engine level. Clean around oil fill and dipstick.
[5]Remove dipstick and wipe clean with cloth.
[6]Tighten dipstick down. Remove & check oil level.
7
