Troubleshooting
Troubleshooting, Adjustment & Service
SUSPENSION ADJUSTMENT
The shock assembly can be adjusted to vary the amount of
Use less
To adjust the spring pre-load:
1. Park machine on a flat, level surface. Disengage |
| |
the PTO, stop the engine and engage the parking |
| |
brake. |
| |
2. See Figure 38. Using the supplied spanner |
| |
wrench (p/n 5022853), insert the tip of the wrench |
| |
into the notch in the |
| |
holding the wrench with both hands, turn |
| |
CLOCKWISE to decrease the |
| |
| ||
Make sure that for each pair of shocks (A, B or C, | WARNING | |
Figure 38) that the | ||
to the same amount of | Use two hands when adjusting the shock | |
NOTE: Spanner wrench is located under the seat. | ||
springs. This will prevent the wrench from | ||
Rear tires must be removed to adjust the rear | ||
slipping while pressure is being applied. | ||
suspension. | ||
|
FRONT | REAR |
|
A | B | C |
Figure 38. Adjust Spring Pre-Load
42 | www.ferrisindustries.com |