CHECK HYDRAULIC OIL LEVEL
1.Before removing the reservoir cap, make sure the area around the reservoir cap and fill neck of the reservoir is free of dust, dirt, or other debris.
2.Unscrew the reservoir cap (B, Figure 19).
3.Look down the filler neck of the hydraulic oil reservoir (A, Figure 19) and observe the oil level. When cold, the oil level should be approximately 4” (10 cm) below top of the filler neck.
4.If necessary, add SAE
5.Reinstall the reservoir cap.
CHANGE HYDRAULIC OIL FILTER
Change Interval: Every 250 Hours
Filter Part Number: 1719168
NOTE: Removing the oil filter from the filter base will drain the oil reservoir. Have a suitable container ready to catch any spilled oil. Ferris recommends this be a
1.Locate the transmission oil filter (E, Figure 20) at the rear of the battery compartment under the seat.
2.Lubricate the new filter base with a few drops of transmission oil. Fill the filter half full of oil.
3.Clean the area around the filter base and remove the filter. Do NOT drain the hydraulic system oil.
4.Thread the new filter onto the filter base until the gasket makes contact, then tighten 3/4 of a turn more.
5.Run the unit for several minutes and check the transmission oil level.
IMPORTANT NOTE: Use caution after changing the filter; air in the hydraulic system may affect the responsiveness of the control levers. Repeat step 5 until the air is out of the system.
BATTERY MAINTENANCE
NOTE: This unit is equipped with a
Cleaning the Battery and Cables
1.Remove the hydraulic oil reservoir mounting hardware (C, Figure 20) and then move the reservoir (D) forward to expose the battery.
2.Disconnect the cables from the battery, negative (black) cable first (B).
3.Clean the battery terminals and cable ends with a wire brush until shiny.
4.Reinstall the battery and reattach the battery cables, positive (red) cable first (A).
5.Coat the cable ends and battery terminals with petroleum jelly or
6.Reposition the oil reservoir and secure in place with the hardware previously removed.
Regular Maintenance
B |
A |
Figure 19. Checking Hydraulic Oil Level
A.Hydraulic Oil Reservoir
B.Reservoir Cap
D |
C |
A |
C |
E |
B |
Figure 20. Battery Compartment
A.Positive (+) Cable & Terminal
B.Negative (-) Cable & Terminal
C.Reservoir Mounting Hardware
D.Hydraulic Oil Reservoir
E.Hydraulic Oil Filter
WARNING
Be careful when handling the battery. Avoid spilling electrolyte. Keep flames and sparks away from the battery.
When removing or installing battery cables, disconnect the negative cable FIRST and reconnect it LAST. If not done in this order, the positive terminal can be shorted to the frame by a tool.
Maintenance
27
