WARNING
•Never use your grill without leak testing all gas connections and hoses. See the section on "Leak Testing" in this manual for proper procedures.
WARNING
The pressure regulator and hose assembly supplied with your gas grill must be used.
•DO NOT attempt to connect it to any other fuel supply source such as a natural gas line.
•DO NOT use any other pressure regulator/hose assembly other than the one supplied with your grill. Replacement pressure regulator/hose assembly must be part No
•DO NOT attempt to adjust or repair the regulator. The regulator is designed to operate at a maximum output pressure of 11 inches of water column (2.74 kPa).
During assembly and/or replacement of the gas cylinder, keep the gas supply hose free of kinks and/or damage.
Visually inspect the hose assembly prior to each use for evidence of damage, excess wear, or deterioration. If found, replace the assembly before using your grill. Only the manufacturer's supplied replacement should be used.
WARNING
CONNECTING HOSE AND REGULATOR TO AN LP GAS CYLINDER
•Ensure the tank valve is CLOSED prior to connecting the LP gas cylinder to your grill. Turn the valve knob clockwise to properly close the valve. Read and follow all instructions and warnings on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe use of LP gas cylinders and the hose and regulator before connecting cylinder to grill. Read and follow all warnings on the LP cylinder.
CONNECTING HOSE AND REGULATOR
1.Check that the cylinder valve is closed by turning the knob clockwise.
2.Check that the grill’s burner control knobs are in the "OFF" positions.
3.Remove the protective plastic cap from the cylinder valve and the connection device.
4.Hold regulator and insert the nipple of connection device into the LP cylinder valve outlet. Ensure that the device is centered properly.
5.Turn the large coupling nut clockwise by hand and tighten to a full stop. Take care not to cross thread the coupling nut onto the cylinder valve. Do not
Note: If you are unable to make the connection, repeat Steps 4 and 5.
6.Check that the hose does not contain kinks, does not contact sharp edges, and does not contact surfaces that may become hot during use.
7.Leak check all fittings before lighting your grill. See section on "Leak Testing" in this manual.
7
