LIGHTING THE ROTISSERIE BURNER:
1.Open grill hood before lighting rotisserie burner.
2.Make sure control knob is in the "OFF" position.
3.Push and turn the control knob to the "HIGH" position.
Continue to push in control knob while pressing electronic igniter for
4.Once burner is lit, continue to push and hold control knob for 30 seconds.
5.If ignition does NOT occur in 5 seconds, turn control knob to "OFF”, wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
6.To turn off, turn each control knob clockwise until it locks in the "OFF" position.
IMPORTANT: DO NOT use back rotisserie burner when main burners are in use.
NOTE: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.
MATCH LIGHTING THE ROTISSERIE BURNER:
1.Open grill hood before lighting rotisserie burner.
2.Make sure control knob is in the "OFF" position.
3.Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the lower edge of burner.
4.Push and turn the control knob of that burner to the "HIGH" position. The burner should light within 5 seconds.
5.Once burner is lit, continue to push and hold control knob for 30 seconds.
6.If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat lighting procedure.
7.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual.
LIGHTING THE SIDE BURNER:
1.Remove lid before lighting side burner.
2.Make sure control knob is in the "OFF" position.
3.Push and turn side burner control knob to the "HIGH" position.
4.Press the electronic igniter on the main control panel and hold for
5.If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
6.To turn off, turn each control knob clockwise until it locks in the "OFF" position.
BACK SIDE BURNER FRONT
O F F
O F F
H I G H
H I G H
NOTE: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.
11
