PARTS LIST
INSPECT CONTENTS TO ENSURE ALL PARTS
ARE INCLUDED AND UNDAMAGED.
INSTALLATION AND OPERATING
INSTRUCTIONS
ASSEMBLING YOUR COPPER TORCHLIGHT
Step 1
The stake has been
Step 2
Using rubber mallet, drive stake into firm, level ground 10 to 12 inches.
NOTE: Ground can be softened with water, however, stake must be stable prior to lighting torchlight.
WARNING
•Install stake into firm, level, soil/ground a minimum of 10 to 12 inches. Make sure stake is stable in ground before operating torchlight.
•Torchlights are only to be installed a minimum of 8 feet from building walls or overhang.
Step 3
Place copper torchlight securely on top of ground stake.
FILLING YOUR COPPER TORCHLIGHT
Step 1
Remove torchlight from ground stake.
Step 2
Remove brass cap and wick assembly from torchlight by turning
WARNING
•DO NOT use gasoline, kerosene, alcohol, or other flammable fuel in or around this torchlight.
Step 3
Reinsert wick assembly into torchlight and screw top cap back onto the torchlight. Use caution to avoid spilling oil. Before lighting, clean excess oil that may have spilled over onto torchlight or surface below torchlight.
LIGHTING YOUR COPPER TORCHLIGHT
WARNING
•DO NOT operate this torchlight until you have read and understand all of the warnings and instructions in this manual.
•Keep children, pets, loose clothing and hair safely away from torchlight. Failure to adhere to this could lead to severe personal injury.
Step 1
Extend wick to no more than 1/2" above top cap.
Step 2
Allow 15 minutes for wick to become completely saturated with oil before lighting. Use long match/long nose lighter to light wick.
AFTER-USE SAFETY
EXTINGUISHING YOUR COPPER TORCHLIGHT
WARNING
•The metal surface can get VERY HOT and caution must be used when handling torchlight after use. Never move torchlight when in use or immediately after use when torchlight and oil may be hot.
•Always place snuffer cap over flame and wick and leave in place until flame has completely extinguished before leaving unattended.
•Allow torch to completely cool before handling.
•Empty remaining oil in torchlight prior to storage. Store oil in its original or a properly sealed container away from any heat source.Empty remaining oil in torchlight prior to storage. Store oil in its original or a properly sealed container away from any heat source.
PROPER CARE & MAINTENANCE
•Allow torchlight to cool, then clean outside by wiping with a damp cloth to minimize accumulation of smoke residue.