OPERATING INSTRUCTIONS
READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL BEFORE OPERATING SPOTLIGHT.
Step 1: To activate spotlight, plug the cigarette lighter adapter into a cigarette lighter receptacle. Move switch to ON.
WARNING: Never place spotlight face down when light is on or is still hot from recent use. Doing so could burn/ignite surfaces such as seats, carpeting, etc. and cause major property damage. Always turn spotlight off and unplug from power source when not in use.
Step 2: To deactivate, move switch to OFF and unplug from power source.
Only use a Brinkmann halogen bulb that is designed for the
IMPORTANT: Do not touch the glass part of bulb with fingers as natural oils affect the life and performance of bulb. Handle bulb by metal end only.
Step 1: Disconnect spotlight from power source.
Step 2: Remove the two screws from top and bottom of front housing (see Figure 1).
Step 3: Lay the spotlight face (lens) down on a flat surface.
Step 4: Holding the front housing secure, slowly lift the rear housing off being careful not to pull wire connections inside. Make sure the reflector is inside the front housing as shown in Figure 2. Do not touch the inside of reflector.
NOTE: The glass lens is not attached to front housing. Use care when disassembling to avoid breaking lens.
To Replace Bulb
Rear
HousingReflector
MAX MILLION II 2,000,000 CANDLEPOWER
FrontLens
Housing
FIGURE 1
2
