P2219_R02f.qxd 11/7/2002 10:23 AM Page 16

Installation

 

 

Lap Belt Installation

 

Figure A illustrates a typical lap belt

 

configuration.

 

1 Insert recline bar into holes on

 

rear of restraint (See page 18).

 

2 Place the child restraint in a

A

forward facing position on the

vehicle seat.

 

3 Pull the vehicle belt out, then pass

 

the vehicle belt through the first belt

 

slot, from the front of the restraint to

 

the rear (Fig. B).

 

4 Route the vehicle belt around

 

the back of the restraint then

 

through the second belt slot,

 

from the rear of the restraint to

B

the front (Fig. C).

 

C

14

5 Verify that the vehicle belt is not twisted, then buckle. (Fig. D).

6 Push restraint into the vehicle seat with your full weight while removing all slack from the vehicle belt (Fig. E).

7 Verify that the vehicle belt is tight and the child restraint is secure.

Installation can be improved by the use of the Versa-Tether(see pages 16–17).

IMPORTANT: Always use the Versa-Tether for children weighing more than 50 pounds (22.6 kg).

Removal

To remove the child restraint, unfasten the vehicle belt and reverse the above directions.

Installation

D

E

15