Care and Maintenance

 

 

 

Cover Removal

 

 

 

 

 

 

TIP: Use a blunt rod or tweezers to

 

7

7

assist with tucking and untucking

 

 

 

the cover from hooks in the shell.

6

 

6

 

 

To remove base/backrest cover:

6

 

6

1 Unfasten hooks (2x) at rear of

 

5

5

 

 

 

 

 

booster seat (fig. A-1).

 

3

3

2 Release fabric from attachment

 

 

 

 

 

points (4x) on sides of backrest at

2

 

2

rear of booster seat (fig. A-2).

2

 

2

3 Unhook elastic loops from

 

attachment points on upper rear of

 

 

 

backrest (2x) and lower rear of

3

 

3

backrest (2x) (fig. A-3).

 

 

 

 

 

 

To remove headrest cover:

 

4

1 1 4

4 Unhook elastic loops (2x) from

A

 

 

attachment points on rear of base

 

 

(fig. A-4).

 

 

 

 

 

 

5 Unhook elastic loops (2x) from attachment points on bottom rear of headrest (fig. A-5).

6 Release fabric from attachment points (4x) on sides of headrest at rear of booster seat (fig. A-6).

7 Unhook elastic loops (2x) from attachment points on top rear of headrest (fig. A-7).

Refitting the Cover

To refit headrest cover:

1 Hook elastic loops (2x) to attachment points on top rear of headrest (fig. A-7).

12

Care and Maintenance

2 Hook elastic loops (2x) to attachment points on bottom rear of headrest (fig. A-5).

3 Fit sides of headrest cover around headrest.

4 Route each elastic from bottom of headrest cover in front of backrest, then through the slot to the rear of the booster seat and hook elastic loop to attachment point on rear of base (2x) (fig. A-4). 5 Tuck adjacent fabric behind attachment points (4x) on sides of headrest at rear of booster seat (fig. A-6).

To refit base/backrest cover:

6 Fit seat section of cover over base, then thread elastic loops through slots between the base and backrest.

7Fasten hooks (2x) to opposite side elastic loops at rear of booster seat (fig. A-1). When attached properly, the elastic will cross at the rear of the base.

8Loosely fit cover over side wings, then hook elastic loops to attachment points on upper rear of backrest (2x) and lower rear of backrest (2x) (fig. A-3).

9Tuck adjacent fabric behind attachment points (4x) on sides of backrest at rear of booster seat (fig. A-2).

Cleaning the Cover

HAND WASH, using cold water and mild soap.
LINE DRY, to prevent cover from shrinking.
DO NOT: Bleach, machine wash, or machine dry.

Cleaning the Shell

SPONGE CLEAN, using warm water and mild soap.
TOWEL DRY

DO NOT: Use solvents, abrasive cleaners, or disassemble booster seat in any way, except as instructed.

13