Installation Without Base

Lap-Shoulder Belt Installation

•Figure A illustrates a typical rear facing lap- shoulder belt installation of restraint only.

WARNING: Do not install this restraint using a non-locking ELR vehicle belt, unless a locking clip is used. Refer to the vehicle owner's manual for instructions on correct use of vehicle belts with child restraints.

1Place the restraint rear facing on the vehicle seat.

2Push cover back to expose belt guides (Fig. B).

3Pull to fully extend vehicle belt.

4With shoulder and lap portion of vehicle seat belt together, route under both belt guides (Fig. C).

A

B

C

Installation Without Base

5Verify that the vehicle belt is not twisted, then buckle (Fig. D).

•When correctly reclined, the red line on restraint will be level with the ground.

•If there is a problem stabilizing the restraint, place a rolled towel in the crease of the vehicle seat to help level the restraint.

WARNING: Only raise restraint as described above. Do not raise the restraint off of D the front edge of vehicle seat; doing so will reduce the protection for your child.

6Push the restraint firmly into the vehicle seat while removing slack from the lap portion of the vehicle belt, then the shoulder portion (Fig. E).

7Adjust handle to In-Vehicle position.

8Verify that vehicle belt is tight and that

the restraint is stable.

E

26

27