Care and Maintenance

Cover & Head Pad

Removal:

1Unhook attachment clips under each handle pivot point.

2Loosen the harness by pressing the adjuster lever located in the front of the restraint, while pulling the harness straps forward as far as possible.

3Unhook the harness straps from the yoke on the bottom of restraint.

4Unbuckle harness and remove the belly pad from the buckle.

5Pull upper harness straps through the shell, cover, and head pad to the top of the restraint.

6Remove head pad.

•If removing head pad only, end procedure here. Replace head pad by reversing steps above.

7Gently remove the upper portion of the cover. Be careful not to damage the energy absorbing foam.

8Pull the lower harness straps, buckle tongues, chest clip, and buckle through the slots in the cover.

9Remove cover from the restraint.

WARNING:

•Do not take apart or attempt to take apart the harness. It is unnecessary and dangerous to do so.

•Never remove the buckle tongues from the harness. They cannot be reattached after removal.

Refitting the Cover:

To refit the cover, reverse Cover Removal directions. Make sure that the harness is not twisted.

30

Care and Maintenance

Cleaning the Cover

•HAND WASH, using cold water and mild soap.

•LINE DRY, to prevent cover from shrinking.

•DO NOT: Bleach, machine wash, machine dry, or iron.

Cleaning the Head Pad Cover

•REMOVE CONTENTS OF HEAD PAD, sponge clean with damp sponge and mild detergent.

•HAND WASH COVER ONLY, using cold water and mild soap.

•LINE DRY, to prevent cover from shrinking.

•DO NOT: Bleach, machine wash, machine dry, iron, or disassemble head pad insert.

Cleaning the Shell & Harness

•BRUSH AWAY LOOSE DEBRIS, using a soft bristled brush.

•SPONGE CLEAN, using warm water and mild soap.

•TOWEL DRY

•DO NOT: Use solvents, abrasive cleaners, or bleach. Do not machine wash, machine dry, or disassemble the harness.

Cleaning the Harness Adjuster

WARNING: Periodically check the adjuster area to be sure it is clean and free of food, coins, dirt, and other objects. If debris is present, it must be removed to prevent interference with the adjuster mechanism.

•BRUSH AWAY LOOSE DEBRIS, using a soft bristled brush.

•SPONGE CLEAN, using warm water and mild soap.

•TOWEL DRY

•DO NOT: Use solvents, abrasive cleaners, or disassemble the harness.

31