Using the Restraint
Harness Buckle
To Unfasten Buckle (Fig A):
•Brace the rear of the buckle with hand.
•Use thumb to press release button until tongues are ejected from buckle.
To Fasten Buckle (Fig B):
•Hold the buckle with one hand.
•Use the other hand to insert one tongue at a time into the buckle. Proper connection is confirmed with a positive click after inserting the second buckle tongue.
IMPORTANT: Periodically clean the buckle to ensure proper operation. See section, Cleaning the Buckle, on page 33.
Adjusting Buckle Position
If your child has outgrown the initial buckle position, adjust the buckle position as instructed below.
Remove Buckle
1With restraint removed from the base, pull cover and foam back so the buckle slots are visible.
2Locate metal retainer attached to the opposite end of the buckle strap from the buckle on the top side of the restraint.
A
B
C
Using the Restraint
3Pull retainer up to loosen (Fig C).
4Turn the retainer so that the short side will go down through the slot in the restraint shell to the bottom side of the restraint (Fig. D).
5From the bottom of the restraint, turn the retainer so the short side will go up
through the slot in the restraint shell to D the top side of the restraint.
Replace Buckle
6Turn the retainer so that the short side will go down through the desired slot to the bottom side of the restraint (Fig. E).
7Turn retainer so that the short side will go up through the other slot to the top side of the restraint (Fig F).
8 Replace cover. | E |
9Pull buckle away from restraint until tight, then verify that the strap is not twisted and the release button is facing outward.
F
10 | 11 |