Using the Restraint |
| |
Adjusting Width of Head Pad |
| |
| ||
If your head pad features optional width |
| |
adjustment, use the following steps to |
| |
adjust the head pad. |
| |
To decrease width: |
| |
Squeeze top center of head pad to inflate |
| |
sides to desired width (Fig A). | A | |
To increase width: | ||
| ||
Press release valve, indicated with label on |
| |
| ||
head pad, to deflate head pad to desired |
| |
width. |
| |
Chest Clip |
| |
Securing the Chest Clip |
| |
Secure the chest clip by sliding the harness |
| |
into the slot on the right side of the chest |
| |
clip (Fig B). | B | |
IMPORTANT: The correct height for the | ||
| ||
| ||
chest clip is at the center of the chest, |
| |
| ||
level with the armpits (Fig. C). |
| |
Releasing the Chest Clip |
| |
Release the chest clip by sliding the harness out |
| |
of the slot on the right side of the chest clip. |
| |
| C | |
|
|
Using the Restraint
Recline Adjustment
To adjust recline, turn knob on front of base until desired angle is achieved (Fig. D).
•When correctly reclined, the red line on base will be level with the ground.
•If there is a problem stabilizing the base, place a rolled towel in the crease of the vehicle seat to help level the base.
WARNING: Only raise base as described D above. Do not raise the base off of the front edge of vehicle seat; doing so will reduce the protection for your child.
Attaching Restraint to Base
To install, align restraint rear facing with slots in base, then push down until it clicks into base (Fig. E).
•Pull up from child restraint handle to be sure
it is properly secured. | E |
WARNING: Never attach restraint to base unless the base is secured in a vehicle as described on pages
Removing Restraint from Base
To remove child restraint from base, squeeze release handle on the rear of the restraint, while lifting restraint by handle (Fig. F).
F
12 | 13 |