WHERE NOT TO INSTALL THIS ALARM

Do NOT locate this Smoke/CO Alarm:

•In garages, kitchens, furnace rooms, crawl spaces and unfinished attics. Avoid extremely dusty, dirty or greasy areas.

•Where combustion particles (formed when some- thing burns) are produced. Avoid poorly ventilated kitchens, garages, and furnace rooms. Keep this Smoke/CO Alarm at least 20 feet (6 meters) from a furnace or other fuel burning heat source, or fuel burning appliances (water heater, stove, vehicle, furnace) whenever possible.

•Within 5 feet of any cooking appliance. In air streams near kitchens. Air currents can draw cooking smoke into the smoke sensor and cause unwanted alarms.

•In extremely humid areas. This Alarm should be at least 10 feet (3 meters) from a shower, sauna, humidifier, vaporizer, dishwasher, laundry room, utility room, or other source of high humidity.

•In direct sunlight.

•In turbulent air, like near ceiling fans or open windows. Blowing air may prevent CO or smoke from reaching the sensors.

•Where the temperatures are regularly below 40˚ F (4˚C) or above 100˚ F (38˚ C) including unheated buildings, outdoor rooms, porches, or unfinished attics or basements. Extreme temperatures may shorten component or battery life.

•In insect infested areas. Insects can clog the openings to the sensing chamber.

•Less than 12 inches (305 mm) away from fluorescent lights. Electrical “noise” can interfere with the sensor.

AVOIDING DEAD AIR SPACES

“Dead air” spaces may prevent smoke from reaching the Smoke/CO Alarm. To avoid dead air spaces, fol- low installation recommendations:

On ceilings, install Smoke/CO Alarms as close to the center of the ceiling as possible. If this is not possible, install the Smoke/CO Alarm at least 4 inches (102

mm)from the wall or corner.

On a peaked, gabled, or cathedral ceiling, install first Smoke/CO Alarm within 3 feet (0.9 meters) of the peak of the ceiling, measured

horizontally. Additional

Smoke/CO Alarms may be required depending on the length, angle, etc. of the ceiling's slope. Refer to NFPA 72 for details on require- ments for sloped or

peaked ceilings.

For wall mounting (if allowed by building codes), the top edge of Smoke/CO Alarms should be placed between 4 inches (102 mm) and 6 inches (152 mm) from the wall/ceiling line, below typical “dead air” spaces. NOTE: Position the battery drawer, marked “THIS SIDE UP”, so it faces the ceiling.

6

Page 7 Page 9
Page 8
Image 8
BRK electronic SC6120B Where not to Install this Alarm, Avoiding Dead AIR Spaces, Do not locate this Smoke/CO Alarm
Page 7 Page 9

SC6120B specifications

The BRK electronic SC6120B is a state-of-the-art combination smoke and carbon monoxide (CO) detector designed to provide optimal protection for homes and workplaces. This innovative device is engineered to enhance safety by detecting both smoke from fires and the presence of carbon monoxide, which is often referred to as the "silent killer" due to its odorless and colorless nature.

One of the standout features of the SC6120B is its Voice Alarm system, which emits distinct voice alerts to inform users whether smoke or CO is detected. This audio notification is crucial in emergency situations, as it allows individuals to respond quickly and appropriately. The device also includes a loud, 85-decibel alarm that further enhances alertness in the event of a danger.

The SC6120B utilizes advanced sensing technology to improve detection accuracy. It is equipped with a photoelectric smoke sensor that is known for its rapid response to smoldering fires, which produce smoke without a significant flame. This type of sensor is particularly effective for detecting slow-burning fires, such as those that begin with electrical equipment or household materials. Additionally, the SC6120B has an electrochemical sensor for CO detection, ensuring that it can identify elevated levels of carbon monoxide swiftly.

This unit is also designed for user convenience and reliability. It features a one-button test/hush function that allows users to easily test the unit's functionality or silence false alarms caused by cooking smoke or steam. The SC6120B has a low battery indicator that alerts users when it's time to replace the batteries, ensuring that the device remains operational at all times.

Another remarkable characteristic of the SC6120B is its compact and modern design, making it suitable for various environments, including bedrooms, hallways, and living rooms. It is easy to install, with a battery-operated option that eliminates the need for hardwiring, thus providing flexibility in placement.

In summary, the BRK electronic SC6120B combines innovative features, user-friendly technology, and effective safety detection into one reliable unit. Its dual function of smoke and CO detection, along with its loud alarms and voice notifications, make it an essential device for safeguarding life and property from the dangers of fire and carbon monoxide.
Top Page Image Contents