INSTALL THE DUCTWORK
NOTE: To reduce the risk of fire, use only steel ductwork.
1.Decide where the ductwork will run between the hood and the outside.
2.A straight, short duct run will allow the hood to perform most efficiently.
3.Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few of them as possible.
4.Install a roof or wall cap. Connect 6" round steel ductwork to cap and work back towards hood location. Use duct tape to seal the joints between ductwork sections.
INSTALL MOUNTING
BRACKETS
1.Construct wood wall framing that is flush with interior surface of wall studs.
Make sure:
a)the framing is centered over installation location.
b)the height of the framing will allow the mounting brackets to be secured to the framing within the dimensions shown.
2.After wall surface is finished, secure mount- ing brackets to framing at dimensions shown, using screws provided.
INSTALL THE HOOD
1.Hang the hood from the brackets through the rectangular
The bottom of the hood should be 24" to 30" above the cooking surface.
2.Height adjustment screws provide vertical adjustment.
3.Depth adjustment screws provide horizon- tal adjustment.
4.Secure the hood with additional mounting screws. Use drywall anchors, provided, if wall studs or framing are not available.
-3 -
ROOF CAP
| 6" ROUND | |
| DUCT | |
DECORATIVE | WALL CAP | |
FLUE | ||
| ||
HOOD | 6" ROUND | |
| ||
| ELBOW |
24" TO 30" ABOVE
COOKING SURFACE
FRAMING BEHIND DRYWALL
|
|
|
|
| L |
|
|
|
|
|
| C |
|
|
|
|
|
| L |
|
|
|
|
| 5" |
| |
43 | 5 |
|
|
| 5" |
|
"to |
|
|
|
| ||
|
|
|
|
| ||
| 8 | 49 | 5 | " |
| |
|
|
| 8 |
| ||
|
|
|
|
| ||
|
|
|
|
| above | cooktop |
|
|
|
|
|
| |
435/8"= bottom of hood 24" above cooktop
495/8"= bottom of hood 30" above cooktop
RECTANGULAR CUTOUTS
MOUNTING
BRACKETS
WALL
FRAMING
DEPTH ADJUSTMENT SCREWS
HEIGHT 
ADJUSTMENT 
SCREWS