OPERATION

Controls

The hood is operated using the (7) push-buttons located at eye-level, on the front of the decorative flue.

The light switch turns the halogen lights on and off.

The blower on-low / off switch turns the blower on to its previous running speed. The blower must be turned on using this switch. Turn the blower off by pressing this switch a second time.

The blower speed lower switch lowers the blower’s running speed. This switch works only when the blower is already running.

The blower speed higher switch raises the blower’s running speed. This switch works only if the blower is already running.

The blower speed highest switch turns the blower on to its highest running spped. This switch works at any time.

The timed shut-offswitch allows the blower to run for 10 or 20 minutes before shutting itself off. Push the switch once to set for 10 minutes - twice to set for 20 minutes. This switch works only if the blower is runinng.

The pilot light above the reset switch will light after the blower has run for 30 hours. This is a reminder to clean the grease filter. Once the grease filter has been cleaned and replaced, push the reset switch to turn out the pilot light and start a new 30-hour count.

LIGHT BLOWER BLOWER

SWITCH SPEED SPEED RESET

LOWER HIGHEST

BLOWER BLOWER TIMED

ON-OFF SPEED SHUT-

SWITCH HIGHER OFF

HALOGEN BULBS

This range hood requires two halogen bulbs (Type MR16, 12V, 20W).

To change bulbs:

1.Remove the grease filter.

2.Remove bulbs by pulling them straight down- ward. Do not rotate bulbs.

3.Replace bulbs by aligning the bulb’s pins with the receptacle holes and pushing bulb up- ward.

- 7 -