WIRING
Note: This range hood must be properly grounded.
The unit should be installed by a qualified electrician in accor- dance with all applicable national and local electrical codes.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
WARNING - Improper grounding can result in a risk of electric shock. Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualified electrician install an outlet near the appliance. Position the electrical outlet at a maximum distance of
Fit the plug into the outlet.
(85cm)
FIG. 7
OPERATION
Controls
The light switch turns the lamps on and off.
The blower switch: makes it possible to select the motor operating
speed. Position 0: motor off.
The pilot lamp lights up whenever the blower is on.
LIGHT BLOWER
SWITCH SWITCH
PILOT LAMP
FIG. 8
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a device that will turn on or speed up the blower if it senses excessive heat above the cooking surface.
1)If blower is OFF - it turns blower ON to HIGH speed.
2)If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower, do it from the main electrical panel.
MAINTENANCE
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CARRYING OUT ANY OPERATIONS ON THE APPLIANCE.
Grease Filter
The grease filter should be cleaned frequently. Use a warm detergent solution. Grease filter is dishwasher safe.
To remove the grease filter: remove the grid by moving the 2 slide fasteners “A” (Fig. 2); remove the metal wires and then the grease filter (Fig. 9).
METAL WIRES
GREASE FILTER
FIG. 9
Non-Ducted Recirculation Filter
The
To remove the
1.Remove the grid by moving the 2 side fasteners “A” (Fig. 2).
2.Remove the metal wires (Fig. 6) and replace the
Cleaning
Occasional care will help preserve its fine appearance.
•Clean with warm water and mild detergent only.
•Follow all cleaning by rinsing with clear water.
•Wipe dry with clean, soft cloth.
Light bulbs
This range hood requires two
1.Remove the grid by moving the 2 slide fasteners (A).
2.Replace with light bulbs of the same type (MAX 40W, 120V, Candelabra Base Bulb). CAUTION: BULB MAY BE HOT!
3