PREPARE THE HOOD
3 Remove
Damper/Duct Connector from inside the hood. Set connec- tor aside - with mounting screws and parts bag.
DAMPER/DUCT
CONNECTOR
4 | Remove Wir- |
| ing Cover from |
| inside the hood. |
| Set cover and |
| mounting screw |
| aside. |
WIRING
COVER
5 | Remove either |
| top or back wir- |
| ing knockout and |
| install approved |
| Electrical Cable |
| Clamp. |
ALLURE™ QS1 SERIES
RANGE HOOD
Page 3
PREPARE THE HOOD
AIR CHUTE
7 | Remove Air |
| Chute - held in |
| place with one |
| (1) screw. |
NOTE: Be care- ful not to discon- nect any wires.
8 | Remove Baffle |
| from air chute. |
| BAFFLE |
BAFFLE |
|
| |
ELECTRICAL CABLE CLAMP
| ||
Wiring” section. | (3) #8 SCREWS | LIGHT |
| ||
| PANEL | |
The following |
| |
|
| |
Steps (6 thru | (2) #8 SCREWS |
|
13) are for |
| |
|
| |
DUCTED |
|
|
INSTALLATION |
|
|
ONLY. |
|
|
6 Remove Light Panel - held in place with (3) #8 screws and (2) #8 screws. Disconnect light assembly wire harness
(white connector).
9 |
10
Rotate baffle. Re- insert baffle into air chute (as shown) so that baffle tabs fit all the way into slots in air chute. An audible “click” will be heard when fully installed. This will close off the air flow through the
|
|
SLOTS | TABS |
| |
| |
|
|
| ||
harness, and replace light panel. |
| |
NOTE: Be careful not to trap wires | SUPPORT FIN | |
between support fin and light panel. | ||
|