Broan QS242SS Non-Ducted Installation - Skip to Step, The following, Steps 6 thru, are for, Only

ALLURE® QS2 SERIES RANGE HOOD

PREPARE THE HOOD

Page 3

PREPARE THE HOOD

3 Remove

Teflon®-coated bottom cover from hood.

AIR CHUTE

Set cover and mounting screws aside.

Teflon® is a registered trademark of DuPont.

4	Remove
	Damper/Duct
	Connector
	from inside
	the hood. Set
	connector
	aside - with
	mounting
	screws and
	parts bag.

DAMPER/

DUCT

CONNECTOR

5 Remove either

TEFLON®-COATED BOTTOM COVER

(Held in place with 2 screws)

7	Remove Air
	Chute - held in
	place with one
	(1) screw.

NOTE: Be care- ful not to discon- nect any wires.

8	Remove Baffle
	from air chute.



BAFFLE

BAFFLE

top or back

wiring knock-

out and install

approved

Electrical

Cable Clamp.





ELECTRICAL CABLE CLAMP

Non-Ducted Installation - Skip to Step 15.

The following	(3) #8 SCREWS	LIGHT
Steps (6 thru		PANEL
14) are for	(2) #8 SCREWS
DUCTED
INSTALLATION
ONLY.

9

Rotate baffle. Re- insert baffle into air chute (as shown) so that baffle tabs fit all the way into slots in air chute. An audible “click” will be heard when fully installed. This will close off the air flow through the non-ducted slots on top of hood.

SLOTS



TABS



6 Remove Light Panel - held in place with (3) #8 screws and (2) #8 screws. Disconnect light assembly wire harness

(white connector).

10Re-install air chute, re-connect wire harness, and replace light panel.

NOTE: Be careful not to trap wires between support fin and light panel.

SUPPORT FIN