PREPARE THE HOOD
NON - DUCTED CONFIGURATION
Note: The following materials must be purchased separately for
•Non - Ducted Recirculation Kit, Model RRK51
•1/16” diameter twist drill.
CAUTION: Do not use plastic or rigid metal ducting.
1.Discard discharge collar and damper supplied with the hood. Install the 5” to 6” adapter supplied with the
Recirculation Kit. Fig. 7. | PLENUM |
|
|
| |||
2.Measure the distance “A”. | (3) SCREWS |
|
|
|
|
| |
|
|
|
|
| |||
3.Attach aluminum flexible duct to the 5” | 5” ALUMINUM |
|
| A | |||
FLEX DUCT |
|
|
| ||||
|
| ||||||
adapter. Tape all joints with duct tape. |
|
|
|
|
|
|
|
Fig. 7. | 5” 6” ADAPTER |
|
|
| |||
4.Assemble the recirculation plenum to the | BLOWER |
|
|
| |||
flexible duct. Fig. 7. | COLLAR |
|
|
|
| ||
|
|
|
|
|
|
| |
5.Drill three (3) 1/16” diameter equally spaced holes through the duct and duct
connector of the recirculation | plenum. |
| |
Fig.7. |
|
| FIG. 7 |
6.Secure duct to the plenum’s connector with (3) sheet metal screws (not included). Tape all joints with duct tape. Fig. 7.
PREPARE THE HOOD
NON - DUCTED CONFIGURATION, cont’d.
7.Carefully place the lower decorative flue into the recessed area of the range hood top. Fig. 6
8.Carefully slide the upper decorative flue down inside the lower flue.
Note: air vents must be up. Fig. 6
9.Secure the recirculation plenum to the upper flue with (4) flat head screws. Fig. 8
-8 -
| PLENUM |
| 4 FLAT |
| HEAD |
| SCREWS |
UPPER |
|
FLUE | FIG. 8 |
|
